Shows ForwarderEndpoints for point-to-point topology.Ĭisco IOX command:Used to discovery VPWS instances. Shows information about Any Transport over MPLS (AToM) virtual circuits (VCs) that have been enabled to route Layer 2 packets on a device. Entries with only an 'In' line refer to egress LSPs entries with only an 'Out' line refer to ingress LSPs and entries with both “In” and “Out” lines refer to transit LSPs.

Shows configuration and statistics for LSPs.Įntries may have only an “In” line, only an “Out” line, or both “In” and “Out” lines. Used to discover and associate backup/secondary TE LSPs with primary LSPs. The resulting output from the command is returned. Shows information about the traffic engineering (TE) tunnels that originate at the device where this command is executed. List of commands to send to the remote ios device over the configured provider. It contains incoming and outgoing labels and descriptions of the packets. Shows the tag-switching forwarding table, which is the label switching equivalent of the IP routing table for standard IP routing. Shows information about the interfaces that have been configured for label switching. SNMP discovery cannot be used to obtain this information Identifies which of the backup TE LSPs is active after a fast-reroute (FRR) occurs.Ĭisco IOX (3.5) command:Invoked during TE tunnel discovery to identify which TE LSP is active after an FRR. Show mpls traffic-eng fast-reroute database

SNMP discovery cannot be used to obtain this information. The Command Scheduler feature provides the ability to schedule some EXEC CLI commands to run at specific times or at specified intervals. Identifies link/node protected tunnels that are protected by the SNMP-discovered link/node protected tunnels.Ĭisco IOS command:Invoked during TE tunnel discovery to discover nested link/protected TE tunnels. end DETAILED STEPS Command or Action Purpose Step 1 enable Example: Router> enable Enables privileged EXEC mode. History fortheFirepower Management Center CLI Feature Version Details. Prevents the device from pausing between screens of output.ĭuring the session, the Cisco device uses the terminal length value to determine when to pause during multiple-screen output.Ī value of 0 prevents the device from pausing between screens of output. Appendix A Cisco IOS CLI for Initial Configuration Using the Cisco IOS CLI to Perform Initial Configuration SUMMARY STEPS 1. These notifications from the Cisco router cause confusion when making adjustments. CLI commands for discovery on Cisco devicesĬLI commands for general session operation The CLI show commands for Cisco devices are listed and described in CLI commands for discovery on Cisco devices.

Cisco ios cli